If you’ve never used a concrete mixer before, it can feel a bit intimidating at first, but once you get the hang of it, it’s pretty straightforward. You just need to make sure you combine the materials in the right order and keep things moving so it doesn’t set too soon.
Getting your setup right
Before you even switch it on, make sure the mixer’s on flat and stable ground. It sounds obvious, but if it’s even slightly off, you’ll notice it straight away when it starts turning. Have everything ready and within arm’s reach.
Load the mixer properly
This is the thing most people get wrong. Don’t just throw everything in at once. Start with a bit of water, then add some aggregate, followed by sand and cement. It helps everything blend evenly. Here, you can understand more about making concrete
If you’re unsure about ratios or quantities or need to buy concrete Cheltenham, specialists such as https://www.monstermixconcrete.co.uk/concrete-cheltenham/ give you a clearer idea of what mix you’re aiming for.
Mixing and pouring
Let the mixer do its thing for a few minutes – you’ll see the texture change. You’re looking for a consistency that’s workable, not too dry and not sloppy. When you’re ready, tilt the drum slowly and guide the concrete where you need it. Don’t rush this part – control’s more important than speed.
Cleaning up afterwards
Once you’re done, clean the mixer straight away. If you leave it too long, you’ll have to chisel hardened concrete off later, which is not fun.
